The reasoning Level converter you’ve talked about keeps two bidirectional, open-drain channel by FETs, and two one-way level change networks (HIGH-In and LOW-out) by resisters creating current divider. Bidirectional open-drain levels shifters include (by selecting appropriate FETs) compatible with I2C coach, however it provides set tall- and Low-voltage edges. Buffer-gate sort bidirectional degree shifters like TX010x oriented your bring two sides and any part of it can be allotted to extreme (or minimal) current area, though lines pulled-up may mistake the processor as supersat mentioned previously rather than appropriate 
for I2C.
No slew. No headache. I’m truly grateful observe that you guys made this a breakout panel. One word of care, though. The VCC Isolation ability (which puts the pins in a HighZ condition) works during startup on condition that you connect OE to surface via a pulldown. It does not matter which train powers up basic, but before VCCa railway are energized OE will still be presented reduced, maintaining the pins HighZ. therefore – make the time to link OE to GND with a weak pulldown (10-50k), and then leave the solder jumper connected.
No guarantees, but from rapid look it appears like Tx tools CD4504 might fit the bill. It certainly is dependent on what you’re trying to do along with it. I2C? SPI? Present from 5-20V. Link CHOOSE to GND and you’ll need yourself a A-B CMOS translator.
My teams is continually constructing prototypes which entail combining different off of the rack eval panels with our companies technologies as well as other solitary board microcontrollers, and therefore relatively always in need of shifting levels between devices. After debugging and assessing all of our prototypes, we generally bring the TXB010X group of levels shifters (typically in a smaller plan and obtainable in 1,2,4,6, or 8 little) to all of our custom made panels which will help maintain persistence for debugging.
This board is an easy breakout board getting the indicators to 0.1″ header gaps while simplifying the OE relationship with a solder jumper to VCCA, doing away with higher soldering operate should you just want this device always-on. In times where energy is very important or really beneficial to appear as if a bus might disconnected, the OE pin are ready highest by a GPIO to turn off these devices therefore the outputs is certainly going to a top impedance state.
Due to the fact TXB0104 try mostly intended for push-pull indicators versus open-drain it works well for UART and SPI coach programs, whereas for open-drain indicators such as for instance I2C, the BOB-12009 was a better option (that I additionally usually buy in bulk and stock within our laboratory).
Good-for SPI
I tried stage changing an ADXL362 breakout panel with resistors and only have garbage outside of the panel. Then I bought the TXB0104 slapped some header pins upon it and put in onto my breadboard and got working within a few minutes. I became in a position to operated my SPI_CLOCK_DIV right doing 2 on a 16MHz Arduino and obtain information from the ADXL362. Since I have am going to include the specific TXB0104 processor chip into a custom board I like the concept of obtaining four outlines dealt with with a small base print and parts when compared with using split BSS138s.
levels shifter
although it might-be good, I got confused with degree shifter that may very well benefit I2C coach. The info sheet associated with TI equipment indicates that this board cannot be useful I2C bus level shifting.
Convenient product
This is certainly a convenient and affordable cure for one common difficulty. One problem I went into–and it really is an issue with the IC, not with SparkFun’s breakout board–is that IC will oscillate in the event the burden on any productivity is too big. If you find this is the instance, include a buffer IC downstream on the result.